GPS Shield With SD Card Slot for Arduino ZIGBEE SMART HOME

VEEYEE provides all the technical support!

This is the GPS SR92 module for Arduino with a SD card slot.

This GPS receiver comes with embedded antenna and only needs 5 pins to talk to your Arduino or MCU.

Pin  1:  GND Ground   Pin  2:  VCC Power supply of 3.3 ~ 3.5 VDCPin  3:  TX Port A serial data output (GPS out); N-8-1, NMEA v3.00 outputPin 4:   RX Port A serial data input (GPS in); N-8-1, accepts commands from external applications, e.g. SiRFDemo.Pin 5:   5 PWR_CTRL Hardware controlled power saving pin.            If this function is used, it is usually connected to a GPIO pin of a micro-processor.            "Low": for normal run            "High" or floating: turn off VCC for power saving             Tie it to low if this pin is not used.

For Arduino application, we recommend aspen board: http://www.soliddepot.com/index.php?main_page=product_info&cPath=27&products_id=116

Not only handheld but also any other GPS applications can share the following major featuresof SR-92.

 Easy adoption with best performance Integrated antenna and EMC protection Built-in backup battery allowing hot/warm starts and better performance No external component demand, just connect and use. Minimum RF and EMI efforts Small size of 18 (W) x 21 (L) x 7 (H) (mm) with patch antenna of 18x18x4mm. Fully implementation of ultra-high performance SiRFstarIII single chip architecture High tracking sensitivity of -159dBm Low power consumption of 40mA at full tracking Hardware power saving control pin allowing power off GPS via GPIO SR-92 could be arranged at best reception location inside housing Firmware upgradeable for future potential performance enhancements

GPS Shield With SD Card Slot for Arduino ZIGBEE SMART HOME